How to make a birdfeeder

This is a fairly easy project for making a birdfeeder from a plastic milk jug or juice bottle. This can be used toward Tiger elective 32, Wolf achievement 5e, Wolf elective 13, Bear achievement 5b, or the Webelos Craftsman activity pin (which could also be helpful for completing the Naturalist activity pin).

To make this, you will need a plastic milk jug or juice bottle (with the cap!), a drill, a utility knife (or a hobby knife or good scissors), a hot glue gun, a 5/8" dowel (approximately 12" long, depending on the size of the jug or bottle), and waterproof rope. Optionally, you will need permanent markers or waterproof paints to decorate the birdfeeder once you are done.

First, thoroughly clean the jug and soak it in hot water to remove any labels. Then dry it off.

Next, use the drill to make a small hole in one of the side panels. Use your knife or scissors to cut out an opening so the birds can get in and out. Make sure the bottom of the opening is high enough so that there will be room at the bottom of the jug for plenty of food. Otherwise, you will have to refill the birdfeeder frequently. Depending on the shape of the jug, make a second opening on either the adjacent side or the opposite side.

Drill a 5/8" hole below each of the openings, then slide the wooden dowel through. Use the hot glue gun to seal around the edges where the dowel pokes through the jug.

Drill two holes at the top of the jug, big enough for the rope to fit through. Feed the rope through the holes.

Optionally, you can decorate the birdfeeder with some bright colors to help attract the birds. At the very least, you should paint the wooden perch to help protect it from the weather.

Hang the birdfeeder about 4' to 6' above the ground. Try to pick a place that birds would consider "safe". Hopefully, birds will spot your birdfeeder, and you should have regular visitors after a few days.